Uniden BCD396T Bedienungsanleitung PDF herunterladen

Uniden BCD996T Firmware Revision Notes 1.04.12

As part of Uniden’s commitment to the continued support of the BCD996T, Uniden has, from time to

time, issued firmware updates. This update contains major enhancements to the BCD996T that directly

reflect requests from our customers. Please take a few minutes to read all of these instructions before

applying the update.

Notes:

• This update is cumulative…it incorporates all improvements made in all previous updates. You

need only apply this one update.

• Most update problems are caused by serial port issues. See the troubleshooting hints in the Update

Troubleshooting section if you have problems.

• Two great forums exist for sharing information about this scanner within the user community:

o The RadioReference forums (http://www.RadioReference.com/forums)

o The BCD996T Yahoo! Group (http://groups.yahoo.com/group/BCD996T)

• You must install this update in order to access and apply future updates to your BCD996T.

Contents:

1. What is changed by this update?

2. Backing Up Your Scanner

3. Applying the Update

4. Update Troubleshooting

5. Updating your Registration Information

6. Using the P25 Band Plan Setting

7. Using the Digital End Code Option (Unofficial)

8. Adjusting AGC Parameters (Unofficial)

What is Changed by This Update?

This firmware update makes the following change to your BCD996T scanner:

 Add ESN Checksum

Previous Update 1.03.11

• Add compatibility for the BC-RH96 Remote Head.

• Add WACN display to P25 systems. Hold on a P25 control channel and press FUNC. The SysID

is replaced by the 5-digit hex WACN code.

• Fix “Multi Packet” issue on some P25 systems.

• Fix “Stops on Control Channel” issue for Motorola systems.

• Fix the “Ghost Talkgroups” issue where the incorrect talkgroup can be displayed for P25 systems.

• Fix the issue that causes the display backlight to unexpectedly change from Low to High.

• Improve P25 audio performance in the Auto Threshold mode.

• Improve digital audio performance with AGC when the person transmitting suddenly speaks

loudly.

1 2 3 4 5 6

Inhaltsverzeichnis

Seite 1 - Contents:

Uniden BCD996T Firmware Revision Notes 1.04.12 As part of Uniden’s commitment to the continued support of the BCD996T, Uniden has, from time to time,

Seite 2 - Applying the Update

Backing Up Your Scanner While it doesn’t happen often, it is possible that applying a firmware update could affect some of your scanner’s programmed s

Seite 3 - Update Troubleshooting

Update Troubleshooting Follow these tips to troubleshoot any update problem you encounter: • When prompted, be sure to turn off the scanner, remove t

Seite 4 - ATTENTION!

Using the P25 Band Plan Setting The BCD996T includes two operation modes for P25 systems: explicit mode and implicit mode channel assignment. Explicit

Seite 5

Adjusting AGC Parameters (Unofficial) This setting is neither fully tested nor supported by Uniden America Corp. ATTENTION! This change allows acces

Seite 6 - Analog AGC Settings

Analog AGC Settings To access these settings: 1. Press [HOLD] while turning on the scanner. 2. Turn off the Digital AGC option and turn on the Anal