Uniden BC246T Betriebsanweisung PDF herunterladen (Seite 26)

ScanControl

One Program, Multiple Scanners, Made in USA

o Mode / Step / Alert / LCN / Aud - Data display field for Radio Mode (AUTO, AM, FM,

NFM) setting, Step (KHz) setting, Alert (BCD396T), Alert Level (BCD396T), LCN

(Logical Channel Number) setting, Aud (Audio Type) setting (BCD996T). The

appropriate boxes are grayed out or not visible when the radio in use doesn’t support the

setting or the frequency is designated as a trunked frequency. Clicking on any of these

boxes brings up the Tone/Mode/Step/Alert/ LCN selection screen for the chosen

frequency (See Below).

Figure 20 - Tone / Mode / Step / Alrt / LCN / Audio Select

Motorola Band Plan # – Drop down list of available Motorola Band Plans for the radio in use. This is

normally a value between 1 and 3. By selecting plan #1, #2 or #3 you are selecting that configuration

for setting the appropriate Base, Spacing and Offset parameters. All valid base configurations are then

programmed into the bank when you perform the Program System step.

o Base –Data entry field for Base Frequency in the selected Base Configuration. If a

system is configured as a Type 2 UHF or VHF (Motorola Type II UHF or VHF) then a

Base Frequency must be entered. This box will only appear if the corresponding System

Type is selected above. Default values will appear the first time the System Type is

selected. Consult your radio Operations Guide for appropriate values.

o Spacing – Data entry field for Spacing Frequency in the selected Base Configuration. If

a system is configured as a Type 2 UHF or VHF (Motorola Type II UHF or VHF) then a

Spacing Frequency value must be entered. This box will only appear if the

corresponding System Type is selected above. Default values will appear the first time

the System Type is selected. Consult your Operations Guide for appropriate values.

o Offset – Data entry field for Offset Channel in the selected Base Configuration. If a

system is configured as a Type 2 UHF or VHF (Motorola Type II UHF or VHF) then an

Offset Channel value must be entered. This box will only appear if the corresponding

System Type is selected above. Default values will appear the first time the System Type

is selected. Consult your Operations Guide for appropriate values.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 85 86

Keine Kommentare

Uniden BC246T Betriebsanweisung Seite 26